7010b Radio Firmware Update -

Do not turn off the radio yet. The tool will automatically exit bootloader mode.

Use the method specified by your vendor’s instructions.

If critical issues arise, you may revert to v4.1.9 using the same process with the legacy .bin file. Note that rollback to any version prior to 4.0.0 is not supported due to flash partition changes.

Warning: Do not power down or disconnect the radio during the update. A failed update may require factory service. 7010b Radio Firmware Update

Step 1 – Connect

Step 2 – Launch Programmer

Step 3 – Verify Current Version

Step 4 – Load Firmware File

Step 5 – Flash

Step 6 – Verify

This document describes a step-by-step firmware update process for the 7010b radio (firmware update preparation, execution, verification, and rollback). It assumes a generic firmware update mechanism via USB or serial connection and a vendor-supplied firmware image and tools. Adjust device-specific commands and file names to match your hardware and vendor instructions.

Release Date: April 21, 2026
Product Line: 7010b Series Tactical / Infrastructure Radio
Priority: Recommended

Write the firmware to flash as instructed (e.g., nand write, erase; flash write). Example flow:

Confirm write success messages and reboot.

Verify firmware version from the device console after boot.

New firmware often resets:

---