Biesse Rover Manual Nc 500
Based on aggregated data from service technicians, here are the top alarms a Biesse Rover operator encounters with the NC 500:
| Error Code | Description | Manual Remedy |
|------------|-------------|----------------|
| AL. 37.1 | X-axis overcurrent | Check for physical obstruction on linear rails. Inspect motor cable for chafing. Reset servo drive via NC 500 SERVO menu. |
| AL. 24.6 | Encoder battery voltage low | Replace rechargeable battery on the absolute encoder. Perform Master-Slave realignment procedure (detailed on page 124 of Maintenance Manual). |
| PS. 0001 | Pneumatic pressure low | Verify shop air is 6-7 bar. Check filter regulator on machine back. Manual override: Jog Z-axis up; then press RESET. |
| TOOL 44 | Spindle not oriented | In manual mode, select M19 (orient spindle). If fails, check proximity sensor on spindle nose. Clean with non-abrasive cloth. |
| NC 500 - Soft Limit | Program tries to move beyond machine limits | Go to PARAMETERS > SOFT LIMITS. Adjust temporary value? No – instead, check zero offsets in your CAM post-processor. | Biesse Rover Manual Nc 500
Pro Tip: The NC 500 stores a hidden error log. Press
CTRL + SHIFT + Efrom the main screen (keyboard required) to access the last 200 dry-cycle errors. Based on aggregated data from service technicians, here
N10 G0 G90 G53 Z0 (Safety lift)
N20 T1 M6 (Load tool 1, 10mm end mill)
N30 M3 S18000 (Spindle on)
N40 G0 X100 Y100 (Rapid to corner)
N50 G1 Z-5 F2000 (Plunge)
N60 G1 X500 F5000 (Cut front edge)
N70 G1 Y300 (Cut right edge)
N80 G1 X100 (Cut back edge)
N90 G1 Y100 (Cut left edge)
N100 G0 Z10 (Lift)
N110 M5 (Spindle off)
N120 M30 (End program)
To manually unclamp a stuck tool from the HSK or ISO 30 taper: Pro Tip: The NC 500 stores a hidden error log
The machine must find its home position after every power-up.